Hints and tips

Hello. Today I'm going to show you the steps of building our claw foot bathtub kits. I'm using the kit in 1/48th scale, but the procedure is the same for both! The kit includes a tub, two pairs of feet and the taps. You will also need: paints side cutters or snips sharp knife  superglue cocktail stick UHU or similar tacky glue Firstly, paint the pieces. Leave the small parts attached to the supports for now. If you got any paint on the upper part of the feet, scrape it off with a sharp knife. This will help the glue hold...

Hello. Today I'm going to show you the steps of building our mirror frame kits. I'm using the rectangular kit in 1/48th scale, but the procedure is the same for all! The kit includes a frame, precut mirror piece and precut card backing. You will also need: paints side cutters or snips sharp knife or pointed tweezers cocktail stick UHU or similar tacky glue Firstly, paint the frame while it is still attached to the supports. Snip them off once dry. Slip the mirror piece under the lip of the frame, from the back. Use your knife tip or something...

Here's a quick photo guide to building the toilet roll and holder kit in 1/24th scale. You will need: snips or side cutters acrylic paints superglue Separately paint the pieces, without removing from the supports. Remove the support parts, cutting flat and as close to the piece as you can. Put a tiny dab of superglue on the flat back of the roll, where the supports were. Fit the pieces snugly together. Done! Ready to attach to your bathroom wall. If you'd like to buy this kit - or a finished, painted piece - they are available from my shop...

Here's a quick photo run through of how to put the 1/24th scale toilet brush model together.